Mikuni Brass Float
19.95 Each
29mm Mikuni Smoothbore Parts
|
|
Mikuni Brass Float |
| Specific to the Mikuni 29mm and the Mikuni VM33, 33mm smoothbore carbs. These are brand new floats and will not fit any stock Mikuni carb sizes due to the special size needed for the smoothbore's wider type bowl. | |
|
19.95 Each |
|
|
|
Mikuni Float Bowl Drain Plug |
| This is the approximately 1 inch round drain plug / jet access plug found on the bottom of 29mm and 33 mm round slide smoothbores. It also fits the newer Radial flat-slide 34, 36, 38, and 40mm carbs too. Sold each and brand new Mikuni part. Also available is the new o-ring seal sold separately below. | |
|
9.95 Each |
|
|
|
Mikuni Float Bowl Drain Plug O-Ring |
| This is the o-ring seal made to seal the bowl drain cap listed above. Genuine Mikuni part. | |
|
2.50 Each |
|
|
|
Mikuni Fuel Passage Joint O-Rings |
| This is the seal for the fuel passage tubes and will fit 29mm and 33mm Mikuni Smoothbore carbs only. Both carbs use 12 total of these o-rings. Sold each and genuine Mikuni part. | |
|
1.00 Each |
|
| Other Available Parts We Stock For 29mm Smoothbores - Made in Japan | ||
| Float Valve Assembly
(Needle and Seat for Float) |
24.95 Each | |
| Main Jets | 3.25 each | |
| Idle Jets | 3.95 each | |
Page and Contents © 2007 crc2onlinecatalog.com
